Step 7 Gasket and buttons. Remove the seal around the circumference of the watch casing, as you will be handling the casing a lot and you don’t want to risk tearing the gasket. Using the tweezers, remove the circlips around every button very carefully. When the circlips are removed, you can pull the buttons off. Same on my 3 left buttons on Fenix 6 pro Saphire. The Buttons have a free stroke before contacting the pcba Buttons for the effective click. On the right side the 2 buttons only have one click and nearly no stroke. I think the pcb board ist not centrally aligned before screwing sothat some users have more stroke on the left side and some on the I got my Fenix 7X Sapphire Solar yesterday, updated the firmware to 7.20 (latest shown) and everything seemed to be fine I tried to select an activity via the top right button, pushed it, screen lit up, no list of activities, etc. (worked fine earlier in the day), tried a long press, same issue, short press same issue. The button is If the buttons are still responsive, hold the LIGHT button until it shuts off, then press it again to turn it back on. If the buttons are unresponsive, wait for the battery to drain, and then recharge it. Turn the watch back on and check the buttons for responsiveness. I absolutely love the increased screen size and maps, but for some reason the backlight is not working correctly. I have researched and tried everything I have found in the last 2 weeks. Hooked it to Garmin Express and installed all updates, checked power settings and battery saver settings, made sure DND is off, etc. I'm at a loss. Ever since the last couple of updates (I believe around 2 updates ago), my Fenix 6s Pro has a delay of 2-3 seconds after pressing a button, when the watchface (default one) is shown. It's only the response after the first button press. The watch is on my wrist, showing the watch face, and I press a button. The watch then doesn't respond for 2-3 Fenix 5 not counting steps. Fenix. For about a month my Garmin has stopped counting steps outside of activities. If I cycle the power it may count for a day or two, then stops. I’ve seen a couple of threads w similar probs, anyone find a solution. It looks like the steps are being counted inside activities, so the accelerometer is working 1. Turn off your Garmin watch** 2. Press and hold the down, start, and back buttons 3. Power on your Garmin watch while holding in these two buttons - when watch starts to power up release the power button only 4. Listen carefully for a beep After the first beep release the start button 5. After the second beep release the back button FLhBf6.

garmin fenix 3 buttons not working